GMI-ROT Series - Absolute Rotary Encoder
User Manual
●
During the assembly of the
ENCODER
on the mounting surface, it is necessary to check
that the
ENCODER
r is oriented correctly in an axial and radial direction and that it is
uniformly in contact with the surface.
●
For its correct positioning and centering with respect to the rotating part to be measured,
it is necessary to use a centering or alignment tool that must be provided by the User
and must be adapted to the
ENCODER
configuration and to the user's application.
●
Tighten the fixing screws with the tightening torque suitable for the single
ENCODER
.
When tightening the fastening screws, uneven mechanical stresses must not be
produced.
●
Use screws of the same size as indicated in the dedicated technical data sheets
attached to this document, according to the specific
ENCODER
configuration. Tighten
the screws using a torque wrench: an example of typical tightening torques depending
on the size of the fastening system is shown in the following table.
Table 1 – Typical values of the tightening torques as a function of the size of the fastening
Dimension
Tightening torque [Nm]
M 2,5
0,8
M 3
1,2
M 4
2,8
4.3 Connection and commissioning
The measures indicated below are used to minimize the occurrence of breakdowns or
accidents on the
ENCODER
.
DANGER:
this activity must be performed by a qualified technician.
DANGER:
BEFORE CONNECTING THE ELECTRICAL parts, check
that the power supply to the ENCODER and to the axes is
disconnected.
●
The power supply (also in terms of voltage and frequency) provided by the User must be
adequate to properly power the
ENCODER
and ensure compliance with the electrical
characteristics shown on the dedicated technical data sheets attached to this document,
according to the specific
ENCODER
configuration.
FLUX GmbH - Austria
2022-04, rev00
25/34
