Fluke MicroScanner 2, Руководство пользователя, Страница: 40 / 60

MicroScanner
2
Cable Verifier
Users Manual
32
Using the Toner
You can use the tester with an optional tone probe to
locate cables in bundles, at patch panels, or behind walls.
Use the tester’s IntelliTone
™
mode with an optional Fluke
Networks IP100 or IP200 tone probe. The digital IntelliTone
signal is easier to detect at a distance than analog tones,
and its frequency and encoding eliminate cable
misidentification due to signal bleed and radiated or
ambient noise.
The tester’s analog tone mode is compatible with most tone
probes.
The analog tone mode features the SmartTone
™
function
for positive identification of cables in bundles.
Toning in IntelliTone Mode (optional IntelliTone
probe required)
Refer to Figures 24 and 25.
1
Connect the tester to the cable.
2
Press

to select twisted pair (

) or coaxial (

) cable.
3
Press

until

,
IntelliTone
, and and a scrolling
pattern of 1s and 0s appear on the display (  ,  , and

in Figure 24).
4
To toggle between the two IntelliTone songs press

then

. The display shows the song number (

).
If you press

or

repeatedly, the tester cycles
through the IntelliTone and analog songs.
5
Turn the probe’s rotary switch to

(locate).
6
Use the probe to find the general location of the tone at
a cable rack, patch panel, or behind a wall, as shown in
Figure 25. The
SYNC
LED lights up green when the
probe is receiving the IntelliTone signal.
The probe’s LEDs light up from 1 to 8 as the signal
strength increases. The higher the number, the stronger
the signal.