After a user WiFi connection request, the lower section of the
WiFi Signal
icon ( ) will
flash to indicate that a WiFi session is pending. It will remain flashing until a reading is taken,
then the transmitter will start the WiFi session.
A reading is taken once a minute regardless of the log rate. The WiFi module is deactivated
while a reading is taken. If the transmitter is not logging it will start a WiFi session
immediately.
The
Action Button
allows you to navigate between
Active Channels
.
1.
Press once to change the
Active Channel
that is displayed.
2.
Press and hold the
Action Button
and
WiFi Button
simultaneously for five seconds to
place the transmitter into
Setup Mode.
3.
Press to mute an
Audible Alarm.
Above the
WiFi Button
and
Action Button
is a built-in
Buzzer
(not shown) for alarm and
other indications during use of the transmitter. The
Buzzer
will activate for 30 seconds when
the transmitter detects an alarm.
Pressing either the
WiFi Button
or
Action Button
will mute the alarm. If not required, the
Buzzer
can be turned off in the settings for the transmitter in the
Diligence Cloud
.
The
Alarm LED (Red)
will flash whenever one or more channels is in an active
(unacknowledged) alarm state. It will not flash for high and low alert states but will flash
for
high and low alarm states.
If not required, the
Alarm LED (Red)
can be de-activated in the settings for the transmitter in
the
Diligence Cloud
. This will not impact alarms.
6
Copyright © 2022 Comark Instruments
