Fluke 9640A Series, Инструкция по эксплуатации

Страница: 212 / 324

9640A
Instruction Manual
5-22
15. Set the UUT to the next frequency point at this amplitude listed in Table 5-12, and
repeat steps 13 through 15.
16. Set the UUT to 100kHz at the next amplitude listed in Table 5-12, and repeat steps 11
through 15.
17. Set the UUT output to
STBY
.
Table 5-12. Level Accuracy Test (50
Ω
), High Frequency Test Points, Thermal Power Sensor
Amplitude Frequency Reading P
out
Tolerance
100 kHz P
2
Reference
10 MHz P
3
±0.05 dB
100 MHz P
3
±0.05 dB
300 MHz P
3
±0.10 dB
+16 dBm
1.4 GHz P
3
±0.25 dB
100 kHz P
2
Reference
10 MHz P
3
±0.05 dB
100 MHz P
3
±0.05 dB
300 MHz P
3
±0.10 dB
1.4 GHz P
3
±0.25 dB
3 GHz P
3
±0.30 dB
+13 dBm
4 GHz P
3
±0.50 dB
100 kHz P
2
Reference
10 MHz P
3
±0.05 dB
100 MHz P
3
±0.05 dB
300 MHz P
3
±0.10 dB
1.4 GHz P
3
±0.25 dB
3 GHz P
3
±0.30 dB
+3 dBm
4 GHz P
3
±0.50 dB
18. Connect the 50
Ω
Leveling Head to the 50
Ω
diode power sensor via a precision 50
Ω
Type-N female-to-female adapter. See Figure 5-5 for equipment connections.
19. Set the UUT as follows:
Mode
Leveled Sine
Frequency 100 kHz
Level -7 dBm
Output
OPER
20. Enter the measurement frequency (0.1 MHz) into the power meter to enable cal factor
(frequency) correction.
Note
The recommended power meter has power sensor calibration factors stored
internally in the sensor. Setting the input frequency in the power meter
automatically selects the appropriate cal factor for the measurement.
However, the power sensor may also be accompanied by a table of
calibration factors which must be applied externally.