XXX.X A
3
CHANNEL A
1
X XXX
MANUAL
RANGE
1:1
PROBE
300mV
3V
30V
250V
@RANGE
300A TO 500A
MEASUREMENT
5
Ø1,2,3
N
LOAD
LOAD
2
XXX X
Auto
RANGE
1:1
PROBE
300mV
3V
30V
250V
@RANGE
1A TO 300A
MEASUREMENT
5
4
M
Figure 3. Setup Guide (Meter Mode)
MAINTENANCE
Before each use, assure continued safety by inspecting the
probe. Look for cracks or missing portions of the probe housing
and output cable insulating cover and for loose or weakened
components. Pay particular attention to the insulation
surrounding the probe jaws. If a probe fails this inspection, tape
is shut to prevent unintended operation. To check probe
performance, complete the “Performance Verification” procedure.
WARNING
THESE SERVICING INSTRUCTIONS ARE FOR USE
BY QUALIFIED PERSONNEL ONLY. TO AVOID
ELECTRIC SHOCK, DO NOT PERFORM ANY
SERVICING PROCEDURES UNLESS YOU ARE
QUALIFIED TO DO SO. READ THE INFORMATION
TITLED “SAFETY” AT THE BEGINNING OF THIS
INSTRUCTION SHEET BEFORE PROCEEDING.
Repairs or servicing not covered in this instruction sheet should
be performed only at a Fluke Service Center. A probe under
warranty will be promptly repaired or replaced (at Fluke’s
discretion) and returned at no charge. See the registration card
for warranty terms. If the warranty has lapsed, the probe will be
repaired or replaced and returned for a fixed fee.
Cleaning and Storage
Periodically wipe the case with a damp cloth and detergent; do
not use abrasives or solvents. Open the jaws and wipe the
magnetic pole pieces with a lightly oiled cloth. Do not allow rust
or corrosion to form on the magnetic core ends.