Fluke 6200-2, Руководство пользователя

Страница: 26 / 34

6200-2
Users Manual
18
To perform the IEC Lead test:
1. Connect the IEC lead as indicated on the Tester, see Figure 6.
MEM
PRINT
BON
D
200
mA
BO
ND 25
A
INS
UL- ATIO
N
I
SU
B
LOA
D/ LEA
K
I TO
UCH
IEC
LEAD
ZER
O
CLEAR
I PE
< 3
.5m
A
(0.75mA
POR
TAB
LE
AP
PLI
ANC
E)
INS
ULA
TIO
N
I SU
B
BO
ND
ZE
RO
IEC
LE
AD
EAR
TH
BO
ND
LO
AD
/ LE
AK
ITOU
CH
I TO
UC
H
< 0
.25
mA
R
ISO
> 1
.0 M
Cla
ss I R
ISO
> 2
.0 M
Cla
ss I
I
RPE
< 0
.1
R
ISO
> 1
.0 M
Cla
ss I
R
PE
200
mA
, R
PE
25A
R
PE
< 0
.1
+ LE
AD
PR
OBE
ON
LY W
ITH
CLAS
S II
APP
LIAN
CE
62
00
-2 A
PPL
IAN
CE
TE
STE
R
hdc02.eps
Figure 6. IEC-Lead Test Connections
2. Push

to start the test.
•
The IEC Lead test is done only in the single test mode.
•
Earth bond, insulation, L-N open, L-N short and L-N polarity (UK and AU)
results show on the display.
3. Push

to store the test result, if required.
Note
1. In the case that an earth bond limit of >1 Ω or an insulation test
limit of <2 M Ω are met, the IEC Lead test is prevented.
2. In the case that an earth bond limit is met, but is <1 Ω , the symbol

shows, and the complete IEC Lead test sequence is
performed.
3. If the insulation test value falls below the limit of 1 M Ω both
symbols “<1 M Ω CI and <2 M Ω CII” show on the display.
PELV Test
The PELV (Protective Extra Low Voltage) test measures the voltage on the PROBE PELV
input when the idle screen shows.
To perform the PELV test:
1. Push

to revert to the idle screen if it is not already shown.
2. Connect the test probe to the Tester PROBE PELV input and connect the appliance
to a mains supply socket.
3. Apply the test probe to the test point.
The display shows the test result. If PELV is above the acceptable limit, then
>PEL VAC shows on the display instead of the mains voltage.
4. Push

to store the test result, if required.