HF132PEN_v0501_05
Page 10
3. CONFIGURATION
3.1. INTRODUCTION
This and the following chapters are exclusively meant for electricians and non-operators. In these,
an extensive description of all software settings and hardware connections are provided.
Mounting, electrical installation, start-up and maintenance of the instrument may only
be carried out by trained personnel authorized by the operator of the facility. Personnel
must read and understand this Operating Manual before carrying out its instructions.
The F132-P may only be operated by personnel who are authorized and trained by the
operator of the facility. All instructions in this manual are to be observed.
Ensure that the measuring system is correctly wired up according to the wiring
diagrams. The housing may only be opened by trained personnel.
Take careful notice of the " Safety rules, instructions and precautionary measures" in
the front of this manual.
3.2. PROGRAMMING
SETUP-LEVEL
3.2.1. GENERAL
Configuration of the F132-P is done at SETUP level.
SETUP-level is reached by pressing
PROG
for 7 seconds; during which time, both arrows
will
be displayed.
After 7 seconds
SETUP
is displayed and you have entered the SETUP level
To return to the operator level, press
PROG
for three seconds or wait: if no keys are pressed for
2 minutes, the unit will exit
SETUP
automatically.
SETUP
can be entered at all times while the F132-P remains fully operational.
Note:
A pass code may be required to enter
SETUP
. Without this pass code access to
SETUP
is
denied.
To enter SETUP-level:
