Flomotion Systems V21, Инструкция по установке и эксплуатации

Страница: 8 / 22

2.3 Pump Mounting and Collet Installation Procedure
1. To install the pump housing on the gearbox, slide it over the central pilot on the gearbox adapter plate.
Next install and torque the mounting screws to 5 NT.M (45 in. oz).
2. Next install the collet on the gearbox shaft. There is a slot in the collet that the flat drive tang on the
gearbox shaft must slide into. Orient the collet to allow the drive tang to slide into the slot and push the
collet completely onto the gearbox shaft. When the collet bottoms out it is in the correct position.
pg. 8
Tubing is shown bent forward out of the pump housing to illustrate the correct tubing
and roller assembly position, prior to sliding the tubing and roller assembly into the
housing and over the collet.