Flomotion Systems V21, Инструкция по установке и эксплуатации

Страница: 21 / 22

6.0 Troubleshooting Guide
Pump does not power up.
No Power to the pump.
Verify the pump is plugged into a powered receptacle and the electrical circuit breaker is in the “ON” position.
Verify the motor and drive power connections for proper wiring.
Pump/Roller Assembly does not rotate.
Roller Assembly was reinstalled incorrectly.
Verify that the roller assembly collet is properly installed/seated and secured on the motor shaft.
Low output capacity
Bad roller adjustment.
Readjust the rollers.
Air leak at the inlet of the pump.
Check the tightness of the tubing connectors at the inlet piping.
Valve closed or partly closed at inlet.
Fully open the valve.
Excess wear of the tubing.
Replace with correct tubing size.
Excess wear of rollers.
Replace with roller assembly spare parts kit, #RK-01.
Product too viscous or pump speed too high compared to the product viscosity.
Ask for advice from your FLOMOTION distributor.
Piping blocked or partly blocked at inlet.
Unblock piping at inlet and make sure there is good flow of the product.
Tubing life is too short.
Incompatibility of the tubing with the pumped product.
Contact your FLOMOTION distributor to verify compatibility.
Discharge pressure and temperature too high.
Verify the discharge pressure and temperature do not exceed the maximum ratings of the pump tubing.
Verify the outlet piping is not blocked up and that all appropriate valves are fully opened.
Check that the pressure relief valve is properly working.
Pump speed too high.
Reduce the pump speed.
Bad roller adjustment.
Check the adjustment.
pg. 21