Flomotion Systems V21, Инструкция по установке и эксплуатации

Страница: 11 / 22

7.
Clean inside of pump housing with damp rag or an
appropriate cleaning solution to remove any chemical
or tubing residue.
Reassembly
1. Reinstall the collet onto the pump shaft.
!
IMPORTANT: There is a slot in the collet that the
flat drive tang on the gearbox shaft must slide into.
Orient the collet to allow the drive tang to slide into
the slot and push the collet completely onto the
gearbox shaft. When the collet bottoms out it is in
the correct position.
2. Mark an 11” section of tubing, which will be the portion, contained within the pump. Leave sufficient
excess on the suction and discharge sides of the pump for the desired connections. If you leave the
excess intake tubing in a coil near the pump it will make it easy to feed a new section of tubing
through the rollers when the section in the pump becomes worn.
pg. 11
Mark an 11”
section of pump tubing.