2001H Series Peristaltic Pump O&M Manual
3. Install tubing into the pumphead.
Note: during tubing installation the loop of tubing may
develop a twist. Examine the tubing for this condition
and if needed turn one end of the tubing where it
exits the tubing clamp to eliminate the twist. Correctly
adjusted the tubing loop will be flat and parallel to the
front face of the pump housing.
4. Loop tubing around roller assembly between guides
as shown. Remove slack in tubing while rotating
roller assembly and sliding onto collet.
Flomotion Systems, Inc. 2001H Series
Pg. 13
