Flomec F116-P, Руководство пользователя

Страница: 8 / 52

Page 8
FL_F116P_v1702_01_EN
2.2 OPERATOR INFORMATION AND FUNCTIONS
In general, the F116-P operates in the operator
mode. The shown information depends on the
settings which are made in the setup menu.
The signal from the connected sensor is processed
by the F116-P in the background, independent from
the selected display refresh rate.
Fig. 3: Process information (typical)
For the Operator, the following functions are available:

Display (differential or summed) total/rate
Total/rate is the main display of the F116-P. After the selection of any other information, it will
always return to this main display automatically. Total is shown on the upper line of the display
and flow rate on the bottom line. When selected in the setup menu, the display shows the flow
rate only or all. When the SELECT/

key is pressed, the other information shows momentarily.
When "-------" is shown, then the flow rate value is too high to be shown. The arrows

indicate
the increase/decrease of the flow rate trend. If the consumption is very low, it might be that a
stable low flow rate and total is shown; this is due to the settings of the F116-P.

Clear total
The value for total can be reset. To do so, press the CLEAR/

key twice. When the key is
pressed once, the text "PUSH CLEAR" is shown. To avoid a reset at this stage, press another
key other than the CLEAR/

key or wait for 20 seconds. A reset of the total does not influence
the accumulated total.

Display accumulated total
When the SELECT/

key is pressed, total and accumulated total are shown. The accumulated
total cannot be reset. The value will count up to 99,999,999,999. The unit and number of
decimals are shown according to the settings for the total.

Display Flow rate-A, Flow rate-B, (accumulated) total-A, (accumulated) total-B
The setting All shows the (differential or summed) flow rate. When the SELECT/

key is pressed
again, the total/accumulated total, the flow rate A, the accumulated total A, the flow rate B and
the accumulated total B are shown temporarily.

Low-battery alarm

Only use original batteries. Original batteries can be ordered at the manufacturer.
The use of unapproved batteries will void the warranty.

At the end of the battery’s life-time, the
voltage starts to drop. When the voltage
becomes too low, the battery indicator comes
on. When the battery indicator is on, install a
new and fresh battery as soon as possible.
Fig. 4: Low-battery alarm (typical)

Alarm
When the alarm indicator is shown, refer to Appendix B: Problem Solving.
R U N