- 5 -
For testing all matchings put all elevator parts into the
section of the fuselage.
Take care for a symmetric position of the elevator and
mark along the fuselage, using a fine and non permanent
marker.
Glue the hinges into the slots in wing and aileron, using CA
or PVA glue. The glue should be very liquid for better
gluing results.
Remove this film along the marks. Be careful and do not
hurt the balsa wood below the film.
Glue the elevator in absolut symmetric position in the section of
fuselage.
Dont forget to put the elevator together with the
steel linkage bracket for elevator flaps into the section of the
fuselage.
Stick the hinges into the elevator using CA or PVA glue. After-
wards glue the flaps to the linkage (epoxy) and hinges (CA or
PVA). Take care, that the flaps are not distorted!!
Mount the rudder rectangular to the elevator and mark with
a fine and non permanent marker along the fuselage.
Remove the covering film along this marks, using a sharp
hobby knife.
Be carefully and dont hurt the balsa wood below the film.
Glue the rudder with 10 min. Epoxy into the slot of body.
