SYS11000OM Rev G
[UF 350-HD, Generic Template]
FLIR Systems Polytech AB
Page
37
of
70
Antennvägen 6
SE-187 66 Täby
Sweden
1.4.21
Menu system functions
To open the menu system, hold
FUNC
(1.4.3) and press the
Ch/Enter
(1.4.4) button once.
This action will open up a menu on the right side of the display that can be navigated with the
UP
and
DOWN
buttons on the
4-Way Switch
(1.4.11).
Ch/Enter
is used to activate menu entries or enter sub-menus.
Pol/Cancel
(1.4.9) is used to close sub-menus and to Exit the menu system.
Note: When the menu system is visible, the regular functions of the gimbal are limited.
Note: Some menu entries may not be available on some system configurations.
Menu Entries;
Top Level
Label
Description
ANTENNA.OFFSET
Sub-menu to configure IMU to GPS antenna offset.
Note: Only on systems with IMU.
IMU.ROTATION
Sub-menu to configure IMU to GPS antenna rotation.
See also § 2.7.2. Calibration IMU
Note: Only on systems with IMU.
DATE/TIME
Sub-menu to configure settings regarding date and time.
VIDEO (TV)
Sub-menu to configure some settings on the TV camera and video outputs.
ALT.REF
IMU altitude reference
[MSL/GeoID]
.
Note: Only on systems with IMU.
GEOTARGET
Submenu for manual setting of Geo-target.
Note: Only on systems with IMU.
MATCH.FOVS
Toggles the "Matched Field of Views" and "Power Zoom" function
[On/Off]
.
When "On", cameras will try to match the current FOV of the active camera.
If both a Spotter and a TV camera is installed in the system, these will be
”connected” and considered as the same camera for the purpose of camera
switching. Zooming in fully on the TV camera, releasing the Zoom button and
pressing it again, will automatically switch to the Spotter camera. Zooming
out fully on the Spotter, releasing the Zoom and pressing it again will
automatically switch to the TV camera. When the feature is "Off", cameras
will keep separate Zoom levels stored, and switching between cameras is
fully manual.
Note: Not available on all systems. (Dependent on payload selection)
