FLIR Ranger R Series, Руководство по установке и обслуживанию

Страница: 51 / 53

910-0001-00-INS -R02 Page 51 of 53
Information contained in this document pertains to a Canadian origin product that is controlled as "dual use" by the Canadian
government. However, when in the United States or possessed by a US person, it may be considered a defense article from the US Government's
perspective. US government authorization may be required for re-transfer to a foreign person. If you have any questions, please contact FLIR's
Global Trade Compliance group at exportquestions@flir.com .
Figure 31 - Verify for loose payload (R5, R5D shown)
7.8 REPLACING THE MEMBRANE GORE VENT
The Gore Membrane Vents are screwed in under the base plate assembly.
The R1, R2, R3, R3D, R5 and R5D have Gore Membrane Vents to even the pressure as well as to
prevent insects and water from entering the radar. The instructions below are given for the
replacement of the Gore Membrane Vents. Contact FLIR Radars Customer Support for help in ordering
new ones.
NOTE: The estimated time to complete this procedure is from 2 minutes to 15 minutes. There is no
need to remove the radome.
Figure 32 - Gore Membrane Vents
Movement < 1mm