To control alarm output devices:
• To enable alarm output devices, select
Schedule
or
Manual
for each device you would
like to enable. Select
Stop
to disable the alarm output device. Click
OK
to save
changes.
• To manually disable activated alarm devices, click
OK
under Alarm Release.
16.3.11
Configuring Hard Drive Warnings
Hard drive warnings will notify you if an issue is detected with the hard drive.
To configure hard drive warnings:
1. From the Main Menu, click
and then click
Event>Warning>HDD
.
2. Under
Event Type
, select the hard drive event you would like to configure.
•
No Disk
: No hard drive detected.
•
Disk Error
: A hard drive error has been detected.
•
Disk Full
: The hard drive is full or almost full. You can enter the percentage of disk
space remaining that will trigger a warning under
Less Than
(e.g. when less than
10% of the hard drive is empty, trigger a warning). Disk Full warnings will not occur if
overwrite is enabled.
•
All
: Configure warnings for all hard drive events.
3. Configure the responses the system will take when the selected event occurs:
•
Alarm Out
: Activate selected alarm out devices. Use
Latch
to select the number of
seconds the alarm out device will be activated.
•
Show Message
: Show a popup message on the monitor.
•
Send Email
: Check to enable email alerts. You must configure email alerts before
you will be able to receive them (see 16.3.5
•
Buzzer
: Check to activate the system buzzer.
4. Click
OK
to save changes.
16.3.12
Configuring Network Warnings
Network warnings will notify you if your system loses connection to the Internet or local
network or if there is an issue on your network.
#LX400057; r. 1.0/24460/24461; en-US
59