| Flightcell
®
DZM Operating Manual | Firmware v2.00
Page 10 of 88 |
The LCD display
The LCD display screen on the DZM has
Main Screen
and
Menu Screen
modes:
The 'Main Screen' displays the operating status of the DZM:
The satellite phone status displays on the 'Main Screen'.
SAT: Powering Up
displays when the DZM has powered up
and is attempting to connect to the satellite phone. The
satellite phone is not available for use at this time.
SAT: Initialising
displays when the DZM is attempting to
initialize the satellite phone. The phone is not available for
use at this time.
If the DZM can’t detect a satellite phone (either because a
phone is not installed in the cradle, or the phone is turned
off, a warning message displays advising that “Sat
phone/LBT is not responding…”.
SAT: Ready
displays when the satellite phone is powered
on, but not in use.
SAT: Calling
displays when the satellite phone is dialing a
number before connection is made.
SAT: On Call
displays when the satellite phone is connected
on a call.
SAT: Disconnecting
displays when a call using the satellite
phone is terminated by the user, if the user doesn’t answer
an incoming call, or if the called party doesn’t pick up the call
within a minute.
Refer to "Making and answering calls" on page 20 for further
information about using the satellite phone to make and
receive calls.
SAT:
Sending Data
displays when the DZM is attempting to
send an SBD or SMS message over the Iridium network.
SMS Sent
or
SBD Sent
shows when a message has been
successfully transmitted.
SMS Failed
or
SBD Failed
display if an SMS or SBD
transmission has failed (usually due to low signal strength).
In this case the DZM will retain the message in the queue
and attempt to resend.
