webdyn.com
V2.0 subject to changes | Webdyn © by Flexitron Group
33
• Passing a magnet twice in less than 10 seconds changes the current mode:
• In STORAGE mode.
• 3 long beeps + 1 long beep: the product executes the action associated with the
magnet (activation of BLE, Diagnosis command, request command) and switches
to RUNmode.
• In RUNmode.
• 1 long beep: the product executes the action associated with the magnet (activation
of BLE, Diagnosis command, request command) and stays in RUNmode.
• Presence of a pressing the RESET button switches back to “factory settings”:
• 1 long beep: the product starts its “factory settings” process.
3.1.1.1 FACTORY SETTINGS Mode
The product is delivered in FACTORY SETTINGS mode if it has no configuration. The hub is then on
standby and its consumption is minimal. When a magnet is passed, a short beep will sound to indicate
that the magnet has been detected, indicate the mode and activate the configuration.
Exiting FACTORY SETTINGS mode is only possible by configuring the product.
The hub can be configured using:
• USB: Connecting the USB cord automatically wakes up the product.
• Bluetooth (BLE): BLE is activated when the magnet is passed over the product.
To optimise battery consumption, the interfaces will automatically shut down after 4 minutes without any
activity. To reactivate the interfaces, a new configuration phase will need to be launched.
The required mode can be set when configuring the product.
To find out whether the WebdynEasy W M-Bus has a customer configuration, check the product’s
commercial reference. (see section 2.2.2: Identification).
3.1.1.2 STORAGE Mode
The product is delivered in STORAGE mode if it has a factory pre-configuration. The hub is then on standby
and its consumption is minimal. When a magnet is passed, a short beep will sound to indicate that the
magnet has been detected and indicate the mode.
Exit from STORAGE mode requires passing a magnet over the hub twice in less than 10 seconds and
switches the hub to RUN mode.
To find out whether the WebdynEasy W M-Bus has a customer configuration, check the product’s
commercial reference. (see section 2.2.2: Identification)
