Flex innovations FlexJet Pro 90 mm, Инструкция по эксплуатации, Страница: 8 / 23

8
9.

Assemble three linkages as shown. Jam nuts are provided for the clevises. Use blue thread lock on all
metal to metal threaded joints to make them secure and to prevent play and thread wear over time.
10.

Fit the servo to the servo hatch as shown noting the slot orientation above and just below. Use the
correct drill for your servo screws (typically about 1/16” or 1.5mm) to dri ll the servo mounting holes.
Screw the servo to the inside of the hatch using the screws provided with the servos.
11.

Drill though the hatch into the wing mount with a 1.5mm (1/16”) bit. Secure the hatch with the
2mm x 6mm Philips washer head sheet metal screws.
12.

Install the linkage and adjust so the control surface is centered.