12
4.
If you are using and Aura 8 AFCS, mount it now using the included mounting tape. Never use hook and
loop to mount a gyro system. It is not stable enough. The fixed platform at the back of the battery tray is
the recommended location. Make the required connections to your receiver. In the final assembly stages
you should further secure your Aura with a strap of hook and loop material.
Install the Elevator Servos
1.
Connect the elevator servo leads to the 600mm (
24”
) servo extensions. Secure the junction so it
cannot be unplugged.
TIP:
Use dental floss to tie the servo lead/extension junction together.
2.
Fit the elevator servos into the servo mounts in the aft fuselage as shown in steps below noting that in
most photos in the sequence the models is
inverted
in a stand.
3.
Use a 1/16” (1.5mm) drill and a pin vise to
drill/clean pilot holes.
4.
Screw the servos in using the screws provided with the servos.
5.
Run the extensions through the tube in the fuselage to the forward part of the model. Plug into the
Aura or receiver as configured. You can also plug the Rudder servo in at this time.
6.
Assemble the Elevator linkages as shown. Jam nuts are provided.
7.
Use blue thread lock on all metal to metal pushrod threads.
Содержание FlexJet Pro 90 mm
Страница 1: ...1 Instruction Manual...