14
TIP:
You can install the stab
arm and ‘rotate’ the parts to the most vertical position possible while the glue
cures.
11.
After the epoxy is cured, install the stab to the fuselage using the circular shims as before.
12.
Use a toothpick to place three tiny drops of epoxy about the side of the head of a pin equally spaced
around the spline of the stab. Install the stab arm in the correct orientation and secure it very snuggly
with the provide socket head sheet metal screw using the provided 2mm hex wrench.
NOTE:
The epoxy on the spline removes any possibility of rotary play in the arm assembly. The arm typically
can be removed later if desired by removing the screw and gently flexing the arm back and forth.
13.
Connect the stab linkages making sure the length is properly adjusted. You can make any further
adjustments to the length by removing the servo arms from the servos. You do not need to disconnect the
clevises or stab arm.
14.
Secure the servo arms to the servos with the screws provided with the servos. Tighten securely. (Put a
very small amount of blue thread lock on the
metal to metal servo screw
threads.
Avoid getting
threadlock on the plastic
)
15.
Install the 1mm x 6mm x 65mm stab trimmer strip by gluing it to the trailing edge of the stab about
20mm from the root end. Top surface only. This mandatory strip helps by pre-loading the stab in high
speed flight.
Содержание FlexJet Pro 90 mm
Страница 1: ...1 Instruction Manual...