13
Install the Stabs and Elevator Linkages
1.
A servo arm hole of not longer than
15mm radius
should be used. Install the linkages onto the servo
arms.
2.
Center the servos and install the servo arm. (Do not install the arm center screws yet, as you can
remove the arms to adjust the length of the linkages. Be sure to secure the center screws once
adjustments are complete). Put threadlock on metal to metal connections ONLY. In the case of the center
servo screw with metal gear servos, put a very small amount of threadlock on screw and keep theadlock
away from the plastic arm.
3.
Trial fit the Stab parts. Assemble the pivot axles into the stabs and lightly snug the 3mm x 8mm SHCSs.
Do not over-tighten as you could strip the threads.
4.
Slide a circular shim over each stab axle.
5.
Insert the stab assemblies into the bearings being careful not to dislodge the inner bearings. Install a
second circular shim over each stab axle.
6.
Check the balance of the stab.
It has leading edge weight applied at the factory. The stab should
balance level or pivot slightly to the nose/leading edge
. If it needs weight in the nose, add weight such as
solder to the front corner and epoxy in place to
make it balance
as noted.
7.
Fit the stab arms onto the splines. Connect the linkages to the outermost stab arm holes (25mm).
8.
Power up the radio and carefully check the function of the stabs. Remove one of the arms and turn the
clevis and arm to adjust the length of the pushrods for correct perpendicular geometry. (Final very minor
tuning can be accomplished later with Aura sub-trim (or Tx sub-trim if not Aura equipped)
9.
Remove the stabs from the aircraft and disassemble the axles from the stabs. Clean the axles with
isopropyl alcohol.
10.
Put a couple of drops of 15 minute epoxy into the axle holes in the stabs, then twist the axles into
place. Put a small drop of epoxy into the screw holes then install and moderately snug the 3mm x 8mm
SHCS screws. This will permanently secure the axle into the stab.
Содержание FlexJet Pro 90 mm
Страница 1: ...1 Instruction Manual...