5
P
neumatic FrameMaster®:
1.
Connect the point driver to the air supply before loading points.
2.
Lay the driver on a table, release the magazine latch and slide the
magazine cover fully open.
3.
Hold a full stack of Framer’s
Points at an angle with the glue
side down, and the sharp end of
the points under the lip of the
magazine groove as shown at A
in Figure 3.
4.
Now lay the stack down so the
pointed ends of the stack
remain trapped under lip A in
the magazine groove.
5.
Push on the End Cap to close and latch the cover.
Figure 3
Pneumatic FlexiMaster®
1.
Release the magazine latch and slide its cover all the way open.
2.
Lay the driver down as shown in Figure 4.
3.
Position a stack of Flexible Framer’s Points with the pointed edge
away from the handle and the glue groove in the points facing
toward you and lay the
stack down.
4. Push on the End Cap to
close and latch the
cover.
Figure 4
A
A
