Flashforge Finder 3, Руководство пользователя

Страница: 20 / 40

Q：
A：
Q：
A：
What if the files on the USB flash disk cannot be identified?
1. Clean and wipe the USB flash disk;
2. Format the USB flash disk;
3. Replace the USB flash disk.
What if the axis cannot be moved?
1. Check the wire of the electric motor;
2. Contact us by email listed.
Email: support@flashforge.com
Q：
A： What if offset occurs on the finished model?
1. Check the tightness of the synchronous belt and ensure it is correctly installed;
2. Slice the model again;
3. Reduce print speed;
4. Make sure operating temperature doesn't exceed its assigned set-point
temperature 30℃.
Q：
A：
Q：
A：
Q：
A：
Printer gets broken at the time of turning it on?
It might be caused by dialing error from switch power supply, please check
whether the voltage is set to the correct value.
Too much filament oozing?
1. Drop the print temperature by 5~10℃;
2. Increase traveling speed, or increase the retraction length and speed.
No filament coming out during printing?
1. Lower the retraction length to avoid abrasion;
2. Check whether the extruder is clogged, use a needle to clean it if necessary.
Q：
A： What if knock and noise occur when nozzle returning to zero point?
1. Check whether the zero sensor is knocked and broken;
2. Check the lines and see whether the noises stop when pressing the sensorby
hand;
3. Contact us by email.
Email: support@flashforge.com
18