Flashforge Finder 3, Руководство пользователя

Страница: 18 / 40

3.6 Printing Notice
The adhesion of glass build plate may decrease after long time using. Please apply
proper amount of glue to keep and improve the adhesion.
Warping issues may occur when print ABS filament in cold environment, you may use
glue to enhance the adhesion. It's not recommended to print ABS filament at
extremely low temperature environment, as print will fail when printed model getting
away from the build plate.
There is a certain quivering on the build plate during the printing which may cause
flatness changed. Thus please pay attention to the adhesion of the first layer when
printing model; if the distance between build plate and nozzle is improper, please
re-level it.
If printing effect is not accurate enough, check the tension of synchronous belt and
make it neither too loose nor too tight.
If there is an error in the height of the Z-axis, please adjust the compensation of the
Z-axis accurately.
Optimal temperature for printing is 18~30℃. Too high or too low temperature is not
good for printing effect.
The lubricity of the X-axis guide rail will decrease after long time use, please apply
an appropriate amount of grease to increase the lubricity. 1.
2.
3.
4.
5.
6.
7.
16