CAUTIONS
Keep the inside of the equipment clean and tidy. Do not drop metal objects into
the slide chute at the bottom of the build plate.
Please clean up the filament debris in time. It is recommended to operate this
outside the equipment.
Any modification of the equipment by yourself will result in that you will not be
entitled to warranty rights anymore.
Please keep the distance between the extruder and build plate for at least 50mm
during filament loading operation. Too-close distance may cause clogged nozzle
issue.
Please operate the equipment in a well-ventilated environment.
Do not use the equipment for illegal activities.
Do not use the equipment to make any food storage products.
Do not put the printed model into your mouth.
03
EQUIPMENT ENVIRONMENT REQUIREMENTS
EQUIPMENT PLACEMENT REQUIREMENTS
COMPATIBLE FILAMENT REQUIREMENTS
FILAMENT STORAGE REQUIREMENTS
The equipment must be placed in a dry and ventilated environment. At least
30cm space must be reserved on the left side and rear side of the equipment, and
at least 60cm space must be reserved on the right side and front side of the
equipment. The storage temperature should be between 0℃ and 40℃.
When using the equipment, it is recommended to use Flashforge filaments. If
non-Flashforge filaments are used, there will be certain differences in material
characteristics, and thus printing parameters may need to be adjusted.
The room temperature should be between 15℃ and 30℃.
The humidity should be between 20RH% and 70RH%.
Please keep the storage environment of filaments dry and dust-free after
unpacking. It is recommended to use the matching drying box for storage.
