Fitness Equipment MLD-M6, Руководство по эксплуатации продукта

Страница: 12 / 30

11
4. Lock the main base (#1) and front frame (#2) together with 2 hex head bolts M10x25 (#65), 4
flat washers
Φ10 (#56) and 2 lock nuts M10 (#75);
5. Attach two counterweight cushions (#32) to each of the two counterweight guide rods (#5) as
shown in the figur;
Installation steps
Figure 2
1. Place counterweight block (#27) into counterweight guide bar (#5) in sequence (groove side
down); attach weight increasing rod bushing (#30) to weight increasing rod (#31), align hole in
weight increasing rod bushing (#30) with topmost hole in weight increasing rod (#31), insert
weight increasing rod retaining pin (#29); then insert the weight increasing rod (#31) into the
middle hole of the counterweight block (#27) and align the hole of the weight increasing rod
(#31) with the groove below the counterweight block (#27).
2. Attach counterweight top block (#26) to counterweight guide bar (#5) and weight increasing rod
(#31), place counterweight block spacer (#28) on top of counterweight block top block (#26) and
insert L-shaped weight increasing pin (#33) into weight increasing rod (#31).
3. Attach pulley single U-frame (#21) to left/right U-frame on front column (#4) with 2 M10x65 hex
head bolts (#69), 4 flat pad Φ10 (#56) and 2 lock nuts M10 (#75); attach the 38x38 square pipe
plug (#45) to the front riser (#4) as shown and sleeve the 38x38 square pipe.
4. Installed to the front bottom frame (#1) with 3 hex head bolts M10x100 (#71, 4 flat washers