FISNAR F1300N.2, Руководство по эксплуатации

Страница: 26 / 64

F1300N.2 Rotary Table Operating Manual
© 2022 Fisnar - 26 - F1300N.2 Rev 01
Z-AXIS DRIVE CYLINDER SETUP
FIG. 8: Z-Axis Drive Cylinder Setup
The machine is supplied with the Z-Axis drive cylinder set at a pre-set (recommended) speed. The
upward and downward speeds are controlled by flow regulators integrated into the push-in fittings
where the “Cylinder In” and “Cylinder Out” tubing connect to the Z-Axis drive cylinder.
The flow regulators act as an air restrictor to control the flow of pressurized air into and out of the
drive cylinder, which in effect controls the movement speed.
The below procedure can be followed should it be necessary to adjust the speed of Z-Axis drive
cylinder.
1.
Unscrew the locking nut on the “Cylinder In” and “Cylinder Out” flow regulator push-in
fitting by turning it counter-clockwise.
2.
Rotate the adjustment screw on the “Cylinder In” flow regulator push-in fitting,
- Clockwise: reduces the downward speed
- Counterclockwise: increases the downward speed
Rotate the adjustment screw on the “Cylinder Out” flow regulator push-in fitting,
- Clockwise: reduces the upward speed
- Counterclockwise: increases the upward speed
3. Touch the “Test Screen” button on the HMI to enter into the Test Screen.