FISNAR F1300N.2, Руководство по эксплуатации

Страница: 29 / 64

F1300N.2 Rotary Table Operating Manual
© 2022 Fisnar - 29 - F1300N.2 Rev 01
3.
Insert the syringe barrel into the syringe barrel holder. Secure in place by gently rotating
the upper locking screw of the syringe barrel until the syringe barrel is held securely in
place with minimum pressure.
4.
Attach a suitable dispense tip to the syringe barrel.
Note:- A low gauge number / larger I.D. dispense tip will dispense a larger diameter dot or
bead width. A high gauge number / smaller I.D. dispense tip will dispense a smaller
diameter dot or bead width.
5.
Gradually apply air pressure (70-100 psi) to the “Main Air In” port on the back of the
machine.
6.
Ensure the fluid pressure gauge on the front panel of the machine is reading 0psi (0 Bar).
Press and keep held down the “Purge” button on the front panel of the machine.
Slowly increase the fluid pressure by rotating the pressure regulator clockwise on the front
of the machine until fluid is dispensed at a steady rate from the dispense tip.
Note:- A low viscosity fluid will require a low pressure value. A high viscosity fluid will
require a high pressure value.
Release the “Purge” button on the front panel of the machine once the anticipated fluid
flow rate from the dispense tip has been achieved.
7.
If a low viscosity fluid is inside the syringe barrel, it may be noticed that fluid is dripping
from the dispense tip. To eliminate this, slowly rotate the vacuum control knob on the front
of the machine in a counterclockwise direction until the dripping stops.
8.
Switch on the power to the machine and then switch the power switch on the back of the
machine to the “On” position.
Allow the machine to boot up into the “Production Screen”.
9. Touch the “Test Screen” button on the HMI to enter into the Test Screen.
10.
Touch the “Cylinder” button on the HMI so it changes to “ON”. The Z-Axis drive assembly
will move downwards to the “DOWN” position.
This is the position where fluid will be dispensed from.