FISNAR F1300N.2, Руководство по эксплуатации

Страница: 8 / 64

F1300N.2 Rotary Table Operating Manual
© 2022 Fisnar - 8 - F1300N.2 Rev 01
1. Purge Button
Press the purge button to manually dispense fluid material from the
syringe barrel or cartridge.
Or, if using a pneumatic dispense valve, press the purge button to
manually actuate the dispense valve.
2.
Suck Back
Control
This feature is only needed if dispensing a low viscosity fluid directly from
a syringe barrel (I.E. syringe barrel adapter assembly is connected
directly to the “Dispense Air Out” port (Fig.4.9) on the back of the
machine).
It will keep a negative air pressure in the syringe barrel other than when
carrying out the “Rotation Delay” and “Dispense Angle” phase of the
program cycle, to prevent low viscosity fluids dripping from the dispense
tip in between program cycles.
3.
Emergency
Stop
Press the emergency stop button to immediately stop the machine and
cease a program cycle.
4. Reset Button
If the emergency stop button is pressed, it will be necessary to press the
reset button after releasing the emergency stop button before the
machine can be actuated again.
5. Start Button
Press both start buttons (5) and (9) simultaneously to actuate the machine
and begin the program cycle.
6.
Dispense
Pressure Gauge
Shows the amount of pressure being used to pressurize the fluid material
in the syringe barrel or cartridge. Or, if using a pneumatic dispense valve,
then this will show the amount of pressure being used to actuate the valve
during the program cycle.
The pressure gauge value is set and controlled by the pressure regulator
(8).
The set pressure is fed out of the back of the machine from the “Dispense
Air Out” port (FIG.4.9) only during the “Rotation Delay” and “Dispense
Angle” phase of the program cycle. Or when the “Purge” button (1) is
pressed.