FISNAR F1300N.2, Руководство по эксплуатации, Страница: 53 / 64

F1300N.2 Rotary Table Operating Manual
© 2022 Fisnar - 53 - F1300N.2 Rev 01
OUTPUT SIGNAL DEFINITION
Pin #5 Alarm Out (Output):
- The signal will be activated if any one of the below conditions occur.
o
If the “Alarm In” input circuit has been activated.
o
If the Emergency Stop Button has been pressed.
o
If the “Door Open” warning message is displayed.
o If the “Reset Machine” warning message is displayed.
o
If the “Home Machine” warning message is displayed.
o If the “Machine Not in Start Position” warning message is displayed.
o
If the “Cycle Count Limit” has been activated.
- If the “Alarm Out” signal is activated during a program cycle, the program cycle will be
automatically stopped.
- It will not be possible to actuate a new program cycle until the “Alarm Out” signal has been
switched off.
- The signal will remain on until the above stated conditions do not occur, whereby the signal will
then be automatically switched off.
Pin #9 Machine Busy (Output):
- When the machine is actuating a program cycle the signal will be activated.
- When the machine is not actuating a program cycle the signal will not be activated.
Pin #11 End of Cycle (Output):
- When the machine has completed a program cycle the signal will be momentarily activated for
a period of 500ms.
Pin #14 Machine Ready (Output):
- After machine power on, the signal will be activated.
- The signal will automatically switch off if any of the below conditions occur.
o “Machine Busy” Output signal activated.
o “End of Cycle” Output signal activated.
o “Alarm Out” Output signal activated.
o Emergency Stop button is pressed.
o
Door Circuit is in an “OPEN” state.
o
A warning message is displayed on the HMI.
o
The machine HMI is not in the “Production Screen”
- The signal will be re-activated automatically when all of the above conditions do not occur.