19
Entering Canister Code
When a new canister of strips is required, the analyzer will request that a canister
code is entered from the new canister. The code can be entered manually from
the keypad, or scanned with the Barcode reader, if installed.
At first startup, the Strip Holder will fully extend. The screen below will be
displayed.
Scan or manually enter the canister code from the strip canister. Press
CLEAR
to
move the cursor to the proper digit. Edit the number as needed. After the last
digit of the correct code is entered, the next screen will be shown. Press
CANCEL
to cancel the changes and exit the screen.
If the canister code is incorrect, the following screen will show.
Press
CANCEL
to exit to the previous screen.
If the canister code is correct, the analyzer will proceed to the Initial Screen.
Note:
Refer to Section 4, Analyzer Setup, to change the settings.
When there are only 5 strips remaining,
will flash to prompt that a new canister
of strips is required. The number of strips left can be seen under
.
When the current run is completed, enter the new canister code. The number
under
will be increased accordingly.
