Fisher Scientific Isotemp 100L Incbtr Grvity 120V, Руководство пользователя

Страница: 16 / 86

,QVWDOODWLRQ
,QWHUPHGLDWH6WRUDJH
*UDYLW\&RQYHFWLRQDQG)RUFHG$LU,QFXEDWRUV )LVKHU6FLHQWLILF
• Transient surges must lie within the range of levels that normally occur in the power
supply system. The impulse withstand voltage based on surge category II of
IEC 60364-4-443 shall be applied at the nominal voltage level.
• Consider installing one dedicated upstream circuit breaker per incubator to avoid multiple
device failures in case of an electrical fault.
&RQWDPLQDWLRQKD]DUG
'RQRWSODFHWKHLQFXEDWRUGLUHFWO\RQWKHODEIORRUEXWPRXQWLW
RQWKHIORRUVWDQGRURQDODEZRUNVXUIDFHRSWLRQWREHRUGHUHG
VHSDUDWHO\&RQWDPLQDQWVVXFKDVEDFWHULDYLUXVHVIXQJL
SULRQVDQGRWKHUELRORJLFDOVXEVWDQFHVPD\XVHWKHRSHQGRRU
WRPLJUDWHHDVLO\IURPWKHIORRULQWRWKHLQFXEDWRU¶VZRUNVSDFH
,QWHUPHGLDWH6WRUDJH
When the incubator is placed in intermediate storage, which is permissible for a maximum of
four weeks, make sure that the ambient temperature is between 20 °C to 60 °C (68 °F to
140 °F) and the maximum relative humidity does not exceed 90%, non-condensing.
5RRP9HQWLODWLRQ
Heat dissipating from the incubator during continuous operation may cause a change in the
room climate.
• Therefore, the incubator must only be installed in rooms with sufficient ventilation.
• Do not install the incubator in room recesses without ventilation.
• When several devices are to be placed in the same room, additional ventilation may have
to be provided as necessary.
• To avoid any impact of the heat dissipated by the incubator on the ambient climate the
room must be vented by means of a laboratory-grade ventilation system that complies
with applicable local and national health and safety regulations and has sufficient capacity.
• If excessive temperatures tend to occur in the operating room, be sure to provide a thermal
protection means that cuts out the power supply to mitigate the impact of over
temperature scenarios.