Lit. No. 72446, Rev. 05
50
November 15, 2020
OPERATING YOUR SNOWPLOW
Manual Unlock Procedure
If the SECURITY GUARD system is activated
and you are using a control programmed with a
different 4-digit code than the one established for
that snowplow, you will be required to manually
enter the correct 4‑digit security code to unlock
the snowplow.
1. Turn the vehicle ignition to the "ON" or
"ACCESSORY" position.
2. Move the ON/OFF switch to the "ON" position
or push the ON/OFF button to switch the
control ON. The power indicator light will flash
rapidly, indicating that the snowplow is locked.
3. Enter the established 4‑digit security code.
4. After the correct security has been entered,
the power indicator light will change from
rapid flashing to steady ON, indicating that the
snowplow has been successfully unlocked.
5. After you have entered your 4‑digit
security code, the FLOAT light will stop
flashing and the power indicator light will
turn OFF. This indicates that your 4‑digit
security code is entered and stored in the
SECURITY GUARD™ system.
NOTE: If the control is turned ON prior to
completing the programming procedure, your
4-digit security code will be cancelled.
Once a 4‑digit security code is established, the
SECURITY GUARD system will recognize any
control that has been programmed with the same
4‑digit security code. If a control not programmed
with the correct 4‑digit code is connected to the
system, the established security code will have to
be entered manually before the snowplow can be
activated (see "Manual Unlock Procedure").
