35
FAULT CODES
If a continuous series of beeps sounds, all the lights turn off on the control panel and a
number appears on the display, a fault has occurred. The washer automatically enters
this mode when there is a fault. The word
Err
will be shown in the control panel display
followed by a number (refer to example shown here). To stop the beeps, touch any button
then perform the following steps:
1
Turn your washer off at the power point.
2
Wait one minute and turn it back on.
3
Check your washer is correctly levelled. Refer to your installation guide.
4
Remove your wash load.
5
Perform a
RINSE
cycle.
6
If the fault re-occurs repeat steps
1
and
2
.
7
If the washer will still not work you will be required to call a Fisher & Paykel trained and
supported service technician to arrange service, refer to ‘Customer Care’ for details.
Record the fault code number displayed and the serial number of your washer (located
above the door opening when the door is open) before calling. The fault code will
indicate to the repairer what the problem could potentially be.
If a fault code is being displayed, you can still turn your washer off by pressing
POWER
.
