Fisher & Paykel Titan AeroTech OD302-B, Руководство по обслуживанию, Страница: 61 / 64

Service Manual 599337A: 302B Series Titan Oven July 2006
61
Door Hinge removal
1. Remove the heat reflective glass pane. (no. 1, refer previous)
2. Loosen the two inner screws on the outer door glass bracket and remove the three
screws down the side of the bracket. (no. 5)
3. Slide the outer door glass bracket clear of the hinge stanchion.
4. Remove the door hinge retaining screw near the top of the stanchion. (no. 10)
5. Lift the door hinge and hinge stanchion enough to clear the edge of the door cap.
(no. 8)
Caution: The inner edges of the stainless steel door cap are sharp.
6. Separate the door hinge from the hinge stanchion. (no. 7)
Reassembly
Refit in reverse manner.
Note: If the upper hinge arm is not loaded, use an
adjustable spanner to lower the upper arm so that
the loading clip from the lower arm can be fitted.
Figure 7.22c
7.23 Meat Probe Socket
Location: Left hand side of the oven cavity
1. Remove the oven from the joinery cavity. (refer
to Section 7.1)
2. Remove the switch service panel adjacent to
the meat probe socket.
3. Remove the retaining nut securing the socket to
the inside of the oven.
4. Remove the meat probe socket through the
inspection hole.
Figure 7.23a
5. Remove the spade terminals from the meat
probe socket.
Reassembly
Refit in reverse manner.
Figure 7.23b
Clip