18
106.
(01101010)
Display to Motor Controller Module Communications Errors
These faults are reported when the Display Module detects an error in the communications
between the Display Module and the Motor Controller Module.
Primary Source
- Display Module.
Action
- Replace Display Module.
Secondary Source
- Motor Controller Module.
Action
Replace Motor Controller Module. If the new Motor Controller Module corrects the fault, refit
the original Display Module.
107.
(01101011) Motor Controller Module Reset Error
The Display Module has detected that the Motor Controller Module has reset when it should not
have. This can be due to a Motor Controller Module supply disturbance or micro processor failure.
Primary source
- Motor Controller Module.
Action -
Replace Motor Controller Module.
130
(10000010) Single Rotor Position Sensor Error
The Motor Controller has found an error in the pattern received from the Rotor Position Sensor.
Likely causes of this fault are a bad connection on the harness between the Rotor Position Sensor
and the Motor Controller Module, or a faulty Rotor Position Sensor.
Primary Source
- Wiring.
Action
1) Check for corrosion on the edge connector of the Rotor Position Sensor and the Motor
Controller Module connector.
2) Check the contacts on the Rotor Positional Sensor end of the Hall Harness to see if any have
been damaged. (Each set of contacts in the socket has two wipers. If the distance between these
wipers varies between different contacts, replace the Rotor Positional Sensor Harness).
Secondary Source
- Rotor Position Sensor.
Action
- Check the Rotor Position Sensor with an R.P.S. tester. Replace if faulty.
Tertiary Source
- Motor Controller Module.
Action
- Replace Motor Controller Module.
131.
(10000011) Repetitive Rotor Position Sensor Error
This fault is similar to fault number 130 above but differs slightly in that it is a continuous
condition. See fault 130 for service procedure.
132.
(10000100) Single Current Trip
The Motor Controller Module has detected excess current in the motor or electronic switches. This
fault has occurred momentarily.
Primary Source
- Wiring.
Secondary Source
- Motor.
Action
