24
Cleaning the condenser filter and evaporator grid
To maintain optimum performance of your dryer the condenser filter and evaporator
grid must be cleaned. A notification will appear on the display panel when the
condenser filter requires cleaning.
●
●
The condenser filter is located below the door on the left-hand side.
●
●
The evaporator grid is located behind the condenser filter.
To clean the condenser filter:
1
Switch off the power supply and remove
the power plug.
2
Open the condenser filter cover.
3
Turn the four condenser lock levers 90°
then pull out the condenser filter.
4
Remove rear filter and wipe the surface
clean with your hand.
IMPORTANT!
If you have stacked your dryer using a Fisher
& Paykel stacking kit, slide the stacking kit
tray out prior to opening the condenser
filter cover.
To clean the evaporator grid:
With the condenser filter removed you
will be able to see the evaporator grid.
If the surface of the evaporator grid is dirty,
clean it carefully with a vacuum cleaner
using a dusting brush or a narrow crevice
nozzle. Be gentle and do not bend the
fine metal fins.
WARNING
Cut Hazard. The surface of the evaporator has sharp edges and contact may result in
injury. Handle with care when cleaning the grid and always keep blades away from
fingers and body.
5
Replace the condenser filter.
6
Turn the four condenser filter lock levers to lock the condenser filter back in place again.
Make sure that these locks are engaged securely.
7
Close the condenser filter cover.
CARING FOR YOUR DRYER
Turning the condenser
filter locking levers
Pulling out the
condenser filter
Содержание DH8060C
Страница 1: ...INSTALLATION GUIDE USER GUIDE NZ AU HEAT PUMP CLOTHES DRYER DH8060C DH9060C models ...
Страница 2: ......
Страница 4: ......