Fisher & Paykel AquaSmart, Инструкция по установке и эксплуатации

Страница: 41 / 112

Changing pre-set options
Controlled Cold
If your incoming cold water temperature is very low you will get a less effective wash. The
CONTROLLED COLD option solves this problem by adding a small amount of hot water to raise
the temperature of the wash to approximately 64°F (18°C).
To programme the CONTROLLED COLD temperature option:
1
Enter Option Adjustment mode (refer to page 36).
2
Select the HEAVY cycle.
3
Select COLD wash temperature by using the WASH TEMP button (if not already selected).
4
The digital display shows the temperature adjustment possible. The default setting is “tAP”, ie the
temperature of the incoming water from the cold cylinder.
■ ■
Touch the MORE button (or the HIGH EFFICIENCY button, depending on your model
of washer) until “0” is displayed. Your washer will now control the cold temperature to
approximately 64°F (18°C). Note: each of the remaining settings equals an approximate
increase or decrease of 0.9°F (0.5°C) from this point.
Wash Temp
OOB Recovery
Factory Reset
EOC Beeps
Wash Temp
OOB Recovery
Factory Reset
EOC Beeps
Fig.26 Changing the Cold wash temperature setting to Controlled Cold
Note: if you always use COLD or CONTROLLED COLD water, we recommend that a WARM or
HOT wash be used regularly, eg every 5th wash should be at least a warm one to maintain the
cleanliness of your washer.
39
US
CA