Fischer Panda 10000/9, Руководство пользователя

Страница: 91 / 246

Installation Instructions
9.12.14 Kapitel/Chapter 7: Installation Instructions - Seite/Page 91
Fig. 7.9.5-1: Vent Screw at the Fuel Stop Solenoid Valve Vent Screw at the fuel stop solenoid valve
Not installed at all models!
7.10 Generator DC system installation
The Panda generators from 6.500 NE upwards have their own dynamo to charge a DC starter battery.
It is recommended to install an additional starter battery for the generator.
The generator is then independent from the remaining battery set. This enables you to start the genset at any time
with its own starter battery even if the other batteries are discharged. A further advantage of a separate starter
battery is that it isolates the generator's electric system from the rest of the boat's DC system, i.e. minus pole (-) is
not connected electrically to Earth/Ground.
The generator is then Earth/Ground free.
7.10.1 Connection of the starter battery block
I An own separate starter battery must be installed for the generator.
The positive cable (+) of the battery is attached directly at the solenoid switch of the starter motor (position 1). The
negative cable (-) of the battery is attached underneath the starter motor at the engine mount (position 2).
NOTE: Panda Generators Panda 6000 and higher normally
provided with an alternator/dynamo to charge the starter
battery. At generators without alternator/dynamo it is
needed to charge the starter battery with an external
battery charger.
ATTENTION! Make sure that the voltage of the starter battery fits to
the start system voltage
f.e. 12 V starter battery for a 12 V start system
f.e. 24 V starter battery for a 24 V start system (2x12 V
batteries in a row)
NOTE: To avoid large voltage drops the battery should be
installed as near as possible to the generator. The
positive terminal of the battery is attached at the red
cable, the negative pole at the blue cable.