FISCHBEIN PBC-6000, Руководство оператора

Страница: 33 / 82

FISCHBEIN
®
Co. MODEL PBC-6000™
OPERATOR’S MANUAL
REV. D 2005-03 33
6. Secure the compression assembly in place by
tightening the ½ inch socket cap screw
(shaft). Double check the alignment of the
compression belt after the screw is tightened.
(
Illustration 8.8
)
7. Push in on the belt between the takeup roller
and the drive sprocket. If the tension in the
belt is correct, the belt should deflect about
½ to ¾ inch (13 – 19mm). (
Illustration
8.10
)
8. Turn “ON” the electrical and pneumatic
supplies to the PBC. You may wish to test a
few bags with the heaters “OFF”. Then test
the compression roller settings with the
heater “ON”. Be sure to allow the manifold
to heat up completely before testing begins.
Follow the guidelines mentioned in the
Quality Control section of this manual to
determine a good seal.
9. Install the top cover over the channels and the rear shrouding.
10. If the rear compression belt is in the correct position, but adjustments need to be made to the
compression force, then adjust the front compression roller as described in the next section.
Illustration 8.9
Illustration 8.8