First Innov PRIMAPROTECT, Уведомление для пользователя и инструкция по установке

Страница: 18 / 28

User notice Primaprotect version 1.0
18
The alarm system can be activated at any time by pressing the button 3 (see illustration
15) of the remote.
The activation of the system is only possible if there is no obstacle in the alignment of one
of the infrared beams. If it’s not the case, the central emits a single low beep.
The deactivation is protected to prevent any intentional deactivation of the alarm system
and to prevent a child from disarming it.
To deactivate the infrared beams, push the button 3 while maintaining the button 5
pressed.
The system is disarmed for 60 minutes after the last crossing of one of the infrared beams.
After this delay, the alarm system rearm itself automatically. The master post emits a
series of beeps and the green LED “ Monitoring” starts blinking.
7 FAILURES
If a failure of the battery pack is detected, the red indicator LED “ Failure” (see illustration
2) of the master post starts blinking and you can hear a short beep every 30 seconds. The
replacement of the battery has to be done as soon as possible. In order to avoid this
dangerous situation, the battery has to be replaced each year at the beginning of the
season.
To identify the failure, dismount the master post and press the button of the electronic
card. The internal LEDs light up to determine the failure.
If none of the LED lights up, the weak battery failure concerns one of the slave posts.
Figure 19 : Button « Installation mode / failure »
VERY IMPORTANT :
The card’s LEDs of the master post light up only if you press the
button. The system enters into « installation » mode for 1h30mn.
When you change the batteries, all you need to do is position the magnetic key on the
reference mark “activation / deactivation” (see figure 3). The system is then temporarily
disarmed (Red LED blinks).
Button installation mode /
Failure
Card’s LED of the
master post