- 15 -
FirmTek, LLC reserves the right to make changes to any products described in this manual at any
time without notice. FirmTek, LLC assumes no responsibility for the use or reliability of hardware
or software that is not supplied by FirmTek, LLC or its affiliated companies. FirmTek, LLC does not
assume any responsibility or liability arising out of the application or use of any product described
in this document, except as expressly agreed to in writing by FirmTek, LLC; nor does the purchase
or use of a product from FirmTek, LLC convey a license under any patent rights, copyrights,
trademark rights, or any other intellectual property rights of FirmTek, LLC or third parties.
VIII. Regulatory Compliance Statements
RoHS compliant
Federal Communications Commission Radio Frequency Interference Statement
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. However, if this equipment does cause interference to radio or television equipment
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between equipment and receiver.
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/television technician for help.
•
Use a shielded and properly grounded I/O cable and power cable to ensure compliance of this unit to the
specified limits of the rules.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CE European Union Compliance Statement
EMC compliance:
Emissions:
EN55022: 1998, Class B
Immunity: EN55024:
1998
EN61000-4-2:
1995+A1:
1998
EN61000-4-3:
1995+A1:
1998
EN61000-4-4:
1995
EN61000-4-6:
1996
EN61000-4-8:
1993
SeriTek/5PMTSLKC2KH0101
