Firman etrailer W02983, Руководство пользователя

Страница: 12 / 123

Page 09
12
13
14
15
Parallel Operation Outlets - These outlets are used
for connecting two eTrailer inverter generators for
parallel operation. A eTrailer parallel kit(optional
equipment) is required for parallel operation.
12V DC outlet – 8
.
3 Amp of DC current may be drawn
from this receptacle.
Use this outlet to charge 12V automotive type
batteries
ONLY
. See 12V DC outlet (Battery
Charger) section.
Remote Start Indicator light - The light will light
or flash depending on the status of the remote start
system.
Remote Start Program Button - Use this button
along with the remote control to program the
generator to be started remotely.
16
DC Circuit Breaker - The circuit protector may be reset
by pushing the button of the protector.
Ground Terminal – Consult an electrician for local
grounding regulations.
17
18 Outlet Cover - Protect the receptacles from dust
and debris.
19
20
21
Fuel Valve Knob
Recoil Stater
Choke Button
Remote Control Programming
1. Flip the engine switch to the " RUN "( l ) position.
NOTE:
YOUR REMOTE CONTROL IS ALREADY PROGRAMMED IN
FACTORY FOR YOUR CONVENIENCE. AND IT IS READY TO
START THE GENERATOR.
Before the generator can be started , an initial
start-up procedure must be performed so the
generator and the remote control recognize
each other.
If the remote control is replaced then you will
need to go through following procedure with
new remote control.
2. Push the battery power restore switch for about
3 seconds and then release.
22
12V DC Battery Charger Port - Plug the 120 Volt
AC charger into this port to charge the generator
battery.
Indicator
Light
Program
Button
3. Press the program button and hold on, the remote
indicator light will light up for about 3 seconds and
then be off. After that, release the program button.
Erase the remote program successfully.
4. Push the program button on the control panel
once and the remote indicator light will light up.
English Customer Service: 1-844-347-6261