Firetide HotPoint 5200, Руководство по установке

Страница: 31 / 32

25
Troubleshooting
This section contains troubleshooting information.
Resetting an outdoor node to factory default settings
Do a reset when you:
•
Remove a device from the field
• Forget the access credential (password)
• Cannot communicate with a device
Caution!
When a HotPort 5200 access point is reset, configuration
information is erased.
Exception:
The system does not erase the USA (840 and 842) country
codes.
To do a software reset with HotView Pro software:
1.
Right-click the access point
> Factory reset this HotPoint
2. When the confirmation message appears, click
Yes
.
For a hardware reset you need:
•
Paper clip, stiff wire, or thin piece of plastic or wood
• Computer with HotView Pro
• Ethernet cable
• Screwdriver or adjustable wrench (depends on model of node)
To do a hardware reset for an outdoor node:
1.
Supply power to the node.
The power LED comes on. After one minute, the node is ready to be reset.
2. Do the step correct for the model of node:
- If the node has a reset screw, use a screwdriver to remove the screw.
- If the node has a pressure valve, use your fingers or adjustable wrench
to remove the valve.
3. Put the screw or valve in a safe place until you finish this procedure.
4. Press and hold for 20 seconds the reset button with the paper clip or other
tool.
5. Wait one minute, and then log in with HotView Pro or web interface.
6. Configure the node or apply a previously saved configuration file.
7. Replace the screw or valve that covers the reset button.
!