Firetide HotPoint 5200, Руководство по установке

Страница: 23 / 32

Outdoor device installation
HotPoint 5200 Access Point Hardware Installation Guide 17
Pole
Spacer nuts go here
(if required)
Flat washer
Lock washer
Nut
4. Hang the access point on the bracket.
5. Tighten the four captive screws.
Antennas for outdoor use
For descriptions of antennas approved for use with HotPoint access points, refer
to the
Firetide Antenna and Accessory Guide
.
Attaching an antenna
The mounting system consists of a pole clamp assembly, a pivot link, and an
antenna bracket.
Required materials: flat washers and lock washers
To attach an antenna to a mast:
1.
Attach the pivot link to the pole clamp assembly. Put a flat washer under the
bolt head. Under the nut put a flat washer and lock washer.
2. Attach the pole clamp assembly to the pole. Put a flat washer under the bolt
heads, and under the nuts put a flat washer and lock washer.
3. Attach the antenna bracket to the antenna so that the mounting lug is
horizontal when the top of the antenna is up.
4. Make sure the polarizations of the antenna is the same between the two ends
of the link.
Mount plate