Firetide HotPoint 5200, Руководство по установке

Страница: 24 / 32

Outdoor device installation
18 HotPoint 5200 Access Point Hardware Installation Guide
Connecting antennas
Antennas are not included with the purchase of a HotPort 5200. This section
describes the common steps to attach an antenna cable to an access point.
Firetide sells antenna cables with or without integrated lightning arrestors.
Unused antenna connectors must be terminated with 50 Ohm terminators (not
included).
To connect antennas with integrated lightning arrestors to a HotPoint 5200
access point:
1.
Remove and discard all six rubber antenna connector covers.
2. Attach the lightning arrestor-side of the cable to the Radio 1 side (left) of
the access point.
- For a MIMO antenna cable, use all three antenna connectors.
- For an OFDM antenna cable, attach the lightning arrestor to antenna
connector 1.
3. Repeat step 2 for Radio 2 (right).
4. If any antenna connectors are not connected to a lightning arrestor, install a
50 Ohm terminator to each uncovered antenna connector.
You are ready to weatherproof all of the connections. See “Weatherproof
procedures” on page 17.
Recommendations for indoor use
If you intend to use the HotPoint 5200 access point inside a building, such as a
warehouse, you need to use special pigtails.
Recommendations for corrosive environments
If you install a HotPoint 5200 access point in a corrosive environment, you must
use rust-proof screws. If you do not use rust-proof screws, you must use extra
strapping or rust-proof safety chains.