Model FS17X
™
Fire and Flame Detector
INSTALLATION GUIDE and OPERATING MANUAL
Fire Sentry Corporation
Document No. 6178-007 - Rev. F
© Copyright 2012
All Rights Reserved
Page 4
SECTION 2: INSTALLATION
2.1
Mounting Instructions
Consider the following guidelines when selecting Detector location:
1. As with all flame and fire Detectors, avoid areas that contain radiant energy sources (such as radiant
heaters, high intensity lamps, flare-stacks, etc.) in close proximity to the Detector’s field of view.
2. Detectors should
not
be mounted outdoors. Additionally, for applications outside of an enclosed wet
bench/tool, use a minimum thirty degree (30°) downward angle with the recommended swivel mount
(Model SM-17).
3. Make sure the Detector has a clear, unobstructed view of the fire threat area. Physical obstructions
between a fire and the Detector may cause the fire to be undetected.
4. The rugged, stable, and calibrated Polypropylene Swivel Mount (SM17) is designed specifically for the
FS17X Detector housings. The mounting clip attaches to the back of the FS17X Detector. The
mounting plate, with the four (4) screw holes, is used for mounting to a solid surface. Each
adjustment increment along an axis is calibrated to 10°. For single axis adjustments, the center
section does not need to be installed.
5. Avoid mounting the Detectors in areas where temperatures exceeds the specified operating
temperature range (see Section 1.2.3).
Figure 2-1
Model
SM17
Swivel Mount
There are no serviceable parts inside the Model FS17X Detector housing. If the Detector housing is opened
up or tampered with, all warranties are voided
Note: Do not attempt to modify the Model FS17X Detector as this voids all warranties.
CAUTION: Disconnect electrical power before unscrewing the Housing Lid.
