Fiplex DH7 Series, Руководство пользователя и инструкция по установке

Страница: 7 / 42

UM-0821 2
FCC Compliance
This is a 90.219 Class B device.
WARNING : This is a 90.219 Class B device. This is NOT a CONSUMER device. It is designed
for installation by FCC LICENSEES and QUALIFIED INSTALLERS . You MUST have an FCC
LICENSE or express consent of an FCC Licensee to operate this device. You MUST register
Class B signal boosters (as defined in 47 CFR 90.219) online at www.fcc.gov/signal-
boosters/registration. Unauthorized use may result in significant forfeiture penalties, including
penalties in excess of $100,000 for each continuing violation. The installation procedure must
result in the signal booster complying with FCC requirements 90.219(d). In order to meet FCC
requirements 90.219(d), it may be necessary for the installer to reduce the UL and/or DL output
power for certain installations.
ATTENTION: This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including
interference that may cause undesired operation.
ATTENTION: FCC regulation mandate that the ERP of type B signal boosters
should not exceed 5W. This Signal Booster has a maximum programmable
composite output power of 5W (+37dBm, and programmable to +30dBm and
+24dBm), therefore the gain of the DL antenna should be of 0dBi or less and
maintain a minimum separation of 45
cm from all persons, and the gain of the UL
antenna should be 13dBi or less and maintain a minimum separation of 45 cm from all persons.
IC Compliance
As per RSS 131 Issue 2:

Nominal passband gain: 80dB max

Nominal bandwidth: 8MHz maximum for Canada market

Rated mean output power: Up to +37dBm maximum, programmable to +30dBm and
+24dBm

Input and Output impedances: 50 ohms
The Manufacturer's rated output power of this equipment is for single carrier operation. For
situations when multiple carrier signals are present, the rating would have to be reduced by 3.5
dB, especially where the output signal is re-radiated and can cause interference to adjacent band
users. This power reduction is to be by means of input power or gain reduction and not by an
attenuator at the output of the device.
RF Exposure Statement for ISED:
“This device complies with Health Canada’s Safety Code. The
installer of this device shouldensure that RF radiation is not emitted in excess of the Health
Canada’s requirement. Information can be obtained at
http://www.hc-sc.gc.ca/ewh-
semt/pubs/radiation/radio_guide-lignes_direct/index-eng.php
”