10
11
Connect red wire from oven to red wire injunction box.
Connect black wire from oven to black wire in junction box.
Connect green ground wire from oven to gray neutral wire in junction box.
The conduit cable, where connected at the oven, swivels. Rotate conduit cable upward (or downward) and direct
through hole prepared in cabinet to attach to J-Box.
To maintain serviceability, the flex conduit must not be shortened and should be routed to permit temporary re-
moval of the oven.
ELECTRICAL INSTALLATION
All model ovens on the front cover are dual rated, designed to be connected to
Either 208/240V AC ,60Hz, 3 wire , two-phase power supply.
Circuit Required
208V,60Hz
240V,60Hz
12AMP
15AMP
The electrical supply should be 3-wire two-phase AC. Install a suitable conduit box(not furnished). An appropriate-
ly-sized, U-listed conduit connector must be used to correctly attach the conduit to the junction box.
Important:
Local Codes may vary; installation, electrical connections and grounding must comply with all appli-
ca- ble local codes.
lf local codes permit grounding through the electrical supply neutral, connect both the white neutral wire and the
bare ground wire from the oven to the white neutral electrical supply wire.
THREE-WIRE CONNECTION
at least 45×560mm .
The panels of the adjacent cabinets must be made of heat-resistant material .In particular ,cabinets with a veneer
exterior must be assembled with glues which can withstand temperatures of up to 10
0
℃
.
In compliance with current safety standards, contact with the electrical parts of the oven must not be possible once
it has been installed.
All parts, which ensure the safe operation of the appliance, must be removable only with the aid of a tool.
To fasten the oven to the cabinet, open the door of the oven and attach it by inserting the 4 wooden screws into the
4 holes located on the perimeter of the frame.
N. B :Installation in compliance with the consumption declaration
In order to ensure adequate ventilation ,the back panel of the cabinet unit must be removed .Installing the oven so that
45 mm
．
560
mm
．
electRicAl inStAllAtion
All model ovens on the front cover are dual rated, designed to be connected to
Either 208/240V AC ,60Hz, 3 wire , two-phase power supply.
Circuit Required
208V,60Hz
240V,60Hz
12AMP
15AMP
The electrical supply should be 3-wire two-phase AC. Install a suitable conduit box(not furnished). An appropriate
-
ly-sized, U-listed conduit connector must be used to correctly attach the conduit to the junction box.
Important:
Local Codes may vary; installation, electrical connections and grounding must comply with all applica
-
ble local codes.
lf local codes permit grounding through the electrical supply neutral, connect both the white neutral wire and the
bare ground wire from the oven to the white neutral electrical supply wire.
tHRee-WiRe connection
Cable from
power supply
Cable
from oven
Grounded Neutral
U.L.-Listed conduit connector
Black wires
Red wires
Green wires
Junction box
Connect red wire from oven to red wire injunction box.
•
Connect black wire from oven to black wire in junction box.
•
Connect green ground wire from oven to gray neutral wire in junction box.
The conduit cable, where connected at the oven, swivels. Rotate conduit cable upward (or downward) and direct
through hole prepared in cabinet to attach to J-Box.
To maintain serviceability, the flex conduit must not be shortened and should be routed to permit temporary re
-
moval of the oven.
